MIL-DTL-25524E(USAF)
ASTM D3701
Standard Test Method for Hydrogen Content of Aviation Turbine Fuels by Low
Resolution Nuclear Magnetic Resonance Spectrometry
ASTM D3828
Standard Test Methods for Flash Point by Setaflash Closed Tester (DoD adopted)
ASTM D3948
Standard Test Methods for Determining Water Separation Characteristics of
Aviation Turbine Fuels by Portable Separometer (DoD adopted)
ASTM D4052
Standard Test Method for Density and Relative Density of Liquids by Digital
Density Meter (DoD adopted)
ASTM D4057
Standard Practice for Manual Sampling of Petroleum and Petroleum Products
ASTM D4177
Standard Practice for Automatic Sampling of Petroleum and Petroleum Products
(DoD adopted)
ASTM D4294
Standard Test Method for Sulfur in Petroleum Products by Energy - Dispersive
X-Ray Fluorescence Spectroscopy (DoD adopted)
ASTM D4306
Standard Practice for Aviation Fuel Sample Containers for Tests Affected by Trace
Contamination
ASTM D4529
Standard Test Method for Estimation of Net Heat of Combustin of Aviation Fuels
ASTM D4809
Standard Test Method for Heat of Combustion of Liquid Hydrocarbon Fuels by
Bomb Calorimeter (Intermediate Precision Method) (DoD adopted)
ASTM D4952
Standard Test Method for Qualitative Analysis for Active Sulfur Species in Fuels
and Solvents (Doctor Test)
ASTM D5006
Standard Test Method for Measurement of Fuel System Icing Inhibitors
(Ether Type) in Aviation Fuels
ASTM D5452
Standard Test Method for Particulate Contamination in Aviation Fuels by
Laboratory Filtration
ASTM D5453
Standard Test Method for Determination of Total Sulfur in Light Hydrocarbons,
Motor Fuels and Oils by Ultraviolet Fluorescence
ASTM D5901
Standard Test Method for Freezing Point of Aviation Fuels (Automated Method)
ASTM D5972
Standard Test Method for Determination of Freezing Point of Aviation Fuels by
Automatic Phase Transition Method
ASTM D6045
Color of Petroleum Products by the Automatic Tristimulus Method
ASTM E29
Standard Practice for Using Significant Digits in Test Data to Determine
Conformance with Specifications
ASTM E380
Standard for Use of International System of Units (SI)
(Application for copies should be addressed to the American Society for Testing and Materials, 100 Barr Harbor
Drive, West Conshohocken PA 19428-2959; (610) 832-9500.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the references cited
herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws
and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2), a sample shall be subjected to first article inspection in accordance
with 4.2.
3.2 Materials. Except as otherwise specified herein, the fuel shall consist completely of hydrocarbon compounds.
Virgin, recycled, or reclaimed petroleum products may be used.
3.3 Chemical and physical requirements. The chemical and physical requirements of the finished fuel
(hydrocarbon blend plus all additives listed herein) shall conform to the requirements listed in section 3 and table
I. Requirements contained herein are not subject to correction for test tolerances.
3.3.1 Storage stability. The finished fuel shall remain stable and conform to the requirements in table I for at
least 1 year when tested in accordance with 4.5.3.
3.4 Additives. The type and amount of each additive used shall be reported (see 6.2e).
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business