MIL-DTL-5624V
4.1.2 Sampling plans.
4.1.2.1 Sampling for conformance inspection. Each bulk or packaged lot (see 6.6) of
material shall be sampled in accordance with ASTM D4057 and ASTM D4177 or both, except
where individual test procedures contain specific sampling instructions.
4.1.2.1.1 Sample containers. Examine the sample container for conformance to ASTM
D4306 recommended sample containers (see 6.5).
4.1.2.2 Sampling for examination of filled containers for delivery. A random sample of
filled containers shall be selected from each lot. The samples shall be examined in accordance
with 4.3.1.3.
4.2 Inspection conditions. The finished fuel shall meet the limiting values in Table II using
the specified test methods. If the finished fuel contains synthesized hydrocarbons, the finished
fuel shall also meet the limiting values in Table IV using the specified test methods. .
4.3 Methods of inspection.
4.3.1 Examination of product.
4.3.1.1 Visual inspection. Samples selected in accordance with 4.1.1 shall be visually
examined for compliance with 3.6.
4.3.1.2 Examination of empty containers. Prior to filling, each empty unit container shall be
visually inspected for cleanliness and prepared for proper usage in accordance with ASTM
D4057.
4.3.1.3 Examination of filled containers. Samples taken as specified in 4.1.2 shall be
examined for conformance to MIL-STD-290 with regard to fill, closure, sealing, leakage,
packaging, packing, and markings.
4.3.2 Chemical and physical tests. Tests to determine conformance to chemical and physical
requirements shall be conducted in accordance with Table II for all finished fuels. For finished
fuels containing synthesized hydrocarbons, tests shall also be conducted in accordance with
Table IV. Requirements contained in Table II and IV are not subject to corrections for test
tolerances. If multiple determinations are made, results falling within any specified repeatability
and reproducibility tolerances shall be averaged to determine conformance to Table II and IV.
The following applies to all specified limits in this standard: For purposes of determining
conformance with this specification, an observed value or a calculated value shall be rounded "to
the nearest unit" in the last right-hand digit used in expressing the specification limit, in
accordance with the rounding method of ASTM E29.
4.3.2.1 Thermal stability. The thermal stability test shall be conducted using ASTM D3241.
The heater tube shall be rated visually (see Annex A1 of ASTM D3241).
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business